| |
- DEPARTMENT OF THE ARMY
TECHNICAL MANUAL
- Organizational Maintenance
Manual
- Organizational Preventive
Maintenance Checks and Services
- Table I. Organizational
Preventive Maintenance Checks and Services
- Figure 31.1. Radiator and
attaching parts.
- APPENDIX I REFERENCES
- APPENDIX II. MAINTENANCE
ALLOCATION CHART
- Maintenance Functions
- Section II. MAINTENANCE
ALLOCATION CHART
- Section II. MAINTENANCE
ALLOCATION CHART
- Section II. MAINTENANCE
ALLOCATION CHART - Continued
- Section II. MAINTENANCE
ALLOCATION CHART - Continued
- Section II. MAINTENANCE
ALLOCATION CHART - Continued
- Section II. MAINTENANCE
ALLOCATION CHART - Continued
- Section II. MAINTENANCE
ALLOCATION CHART - Continued
- Section II. MAINTENANCE
ALLOCATION CHART - Continued
- Section III. TOOL AND TEST
EQUIPMENT REQUIREMENTS
- Organizational Maintenance
Manual
- Figure 16.1. Crankcase
ventilation valve and related parts (Army Model MHE-223)
- Alternator (Army Model MNE
223)
- Figure 41.1. Alternator
output check (Army Model 223)
- Figure 41.2. Shielding kit
(Army Model MHE 223)
- Figure 42.1. Alternator and
attaching parts (Army Model MHE 223).
- Service Brakes (Army Models
MHE 278, 178A, 178B and 178C)
- Figure 77.1. Brake shoe
assemble, exploded view (Army Model MHE 223).
- Figure 77.2. Wheel removed
to show service brakes (Army model MHE 223).
- APPENDIX I REFERENCES
- Painting
- TABLE OF CONTENTS
- CHAPTER I INTRODUCTION
- Tabulated Data
- CHAPTER 2 SERVICE UPON
RECEIPT OF TRUCK
- CHAPTER 3
- Figure 1. Lubrication Order
10-3930-222-20.
- Figure 2. Lubrication
points.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Figure 2-Continued.
- Table I. Maintenance
Indicator Checklist
- Table I. Maintenance
Indicator Checklist-Continued.
- Table 1. Maintenance
Indicator Checklist--Continued.
- Table 1. Maintenance
Indicator Checklist--Continued.
- Table 1. Maintenance
Indicator Checklist--Continued.
- Table 1. Maintenance
Indicator Checklist--Continued.
- Figure 3. Engine, fuel
system, and ignition system troubleshooting charts.
- Figure 3-Continued.
- Figure 4. Cooling system
troubleshooting chart.
- Figure 5. Electrical
starting system troubleshooting chart.
- Figure 6. Electrical
charging system troubleshooting chart.
- Figure 7. Electrical
lighting system troubleshooting chart.
- Figure 8. Electrical horn
system troubleshooting chart.
- Figure 9. Brake
troubleshooting chart.
- Figure 10. Steering
troubleshooting chart.
- Figure 11. Hydraulic
troubleshooting chart.
- Figure 12. Engine removed
from truck, left view.
- Figure 13. Engine removed
from truck, tight view.
- Figure 14. Engine removed
from truck, rear view.
- Figure 15. Engine installed
on truck, top view.
- Figure 16. Cylinder head nut
tightening sequence.
- Figure 17. Engine oil
filter, mounted on engine.
- Figure 18. Engine oil
filter, exploded view.
- Figure 18-Continued.
- Figure 19. Adjusting the
valves.
- Governor
- Figure 20. Carburetor
installed on truck.
- Figure 21. Governor
installed on truck.
- Figure 22. Air cleaner
installed on truck.
- Figure 23. Air cleaner
assembly, exploded view.
- Figure 24. Fuel pump
installed on truck.
- Figure 25. Fuel tank and
attaching parts, exploded view.
- Figure 26. Fuel tank
installed on truck.
- Figure 27. Removing fuel
tank.
- Figure 28. Throttle pedal
linkage, exploded view.
- Figure 29. Exhaust elbow
installed on truck.
- Figure 30. Muffler, exploded
view.
- Figure 31. Heat control
valve, exploded view.
- Radiator
- Fan and Generator V-BeIt
- Figure 32. Hydraulic pump
drive flange yoke installed on truck.
- Figure 33. Water pump,
exploded view.
- Figure 34. Electrical
charging circuit.
- Figure 35. Electrical horn
circuit.
- Figure 37. Electrical
instruments circuit.
- Figure 39. Electrical
starting circuit.
- LOW VOLTAGE CERCUIT TESTER
- Figure 41. Generator,
installed on trock.
- Figure 42. Generator and
attaching parts.
- Figure 43. Voltage regulator
removed from truck.
- Figure 44. Adjusting cutout
relay armature airgap.
- Figure 45. Adjusting cutout
relay point opening.
- Figure 46. Test equipment
for adjusting cutout relay closing voltage.
- Figure 47. Adjusting cutout
relay closing voltage,
- Figure 48. Adjusting voltage
regulator airgap.
- Figure 49. Test equipment
for checking and adjusting voltage regulator.
- Figure 50. Adjusting voltage
regulator.
- Horn and Relay
- Figure 51. Adjusting current
regulator airgap.
- Figure 52. Test equipment
for checking current regulator setting.
- Figure 53. Adjusting current
regulator setting.
- Figure 54. Starting motor
installed an truck.
- Figure 55. Distributor
installed on truck.
- Figure 56. Distributor,
exploded view.
- Figure 57. Interior of
distributor cap.
- Figure 58. Interior of
distributor.
- Figure 59. Crankshaft pulley
and timing gear cover showing timing marks.
- Figure 60. Test equipment
for checking timing by the timing tight method.
- Figure 61. Test equipment
for checking cam dwell.
- Figure 62. Battery and
carrier, exploded view.
- Figure 65. Headlight,
exploded view.
- Figure 65. Horn button
assembly, exploded view.
- Figure 66. Instruments and
gages viewed from rear of instrument panel.
- Section IX. TRANSMISSION
(GROUP 07)
- Figure 67. Transmission oil
filter, exploded view.
- Figure 67-Continued.
- Figure 68. Transmission
lever linkage, exploded view.
- Figure 68-Continued.
- Figure 69. Transmission
lever linkage installed on truck.
- Figure 70. Handbrake
installed on truck.
- Figure 71. Handbrake and
linkage, exploded view.
- Service Brakes
- Figure 72. Brake and inching
controls, exploded view.
- Figure 73. Brake master
cylinder, installed on truck.
- Figure 74. Transmission
control valve and inching spool, installed on truck.
- Figure 75. Wheel removed to
show service brakes.
- Figure 76. Brake master
cylinder, exploded view.
- Figure 77. Wheel cylinder
and attaching parts.
- Steering Wheel Hubs and
Bearings
- Figure 78. Steering wheel
hub and bearings, exploded view.
- Figure 79. Steering wheel
assembly, tire, and tube.
- Figure 81. Drive axle shaft
and hub.
- Section XII. STEERING (GROUP
14)
- Figure 82. Drag link and tie
rod assemblies, exploded view.
- Figure 83. Steering booster
cylinder, exploded view.
- Section XIII. HOOD (GROUP
17), BODY (GROUP 18) AND OVERHEAD GUARD (GROUP 22)
- Figure 84. Hood support
brackets.
- Hydraulic Tank Filter
- Figure 85. Tilt cylinder,
installed on truck.
- Figure 86. Tilt cylinder,
exploded view.
- Figure 87. Hydraulic filter,
installed on truck.
- Figure 88. Hydraulic filter
assembly and air cleaner, exploded view.
- Figure 89. Forks, installed
on truck.
- CHAPTER 4 SHIPMENT, LIMITED
STORAGE, AND DEMOLITION
- Section II. DEMOLITION
- Methods
- APPENDIX I REFERENCES
- APPENDIX II MAINTENANCE
ALLOCATION CHART
- APPENDIX II MAINTENANCE
ALLOCATION CHART - CONT
- APPENDIX II MAINTENANCE
ALLOCATION CHART - CONT
- APPENDIX II MAINTENANCE
ALLOCATION CHART - CONT
- INDEX
- INDEX - CONT
- INDEX - CONT
- INDEX - CONT
- INDEX - CONT
- The Metric System and
Equivalents
- By Order of the Secretary of
the Army:
- TM-10-3930-222-20
- By Order of the Secretary of
the Army:
- BLANK PAGE
- RECOMMENDED CHANGE TO
EQUIPMENT TECHNICAL PUBLICATION
|
|