Figure 22. Air cleaner installed on truck.

TM 10-3930-222-20

Figure 22. Air cleaner installed on truck.

b. Installation. Reverse procedures in a above.

c. Cleaning.

(6) Unscrew and remove the washer (14, fig. 25),

(1) Clean the outside of the fuel tank with SD.

lockwasher (15), and capscrews (16) that secure

clamps (12 and 19) to the truck and remove the

(2) Clean the inside of the fuel tank with SD and

clamps.

then drain. Allow the fuel tank to dry before

refilling it with fuel.

(7) Disconnect and remove the throttle rod (2, fig.

26) from the truck.

31. Throttle Pedal and Linkage

(8) Turn the tank on end (fig. 27) and remove the

tank from the truck.

a. Removal.

(9) Unscrew and remove the shutoff valve (11, fig.

(1) Remove the rear floor plate.

25) and fitting (10) from the tank.

(2) Disconnect the throttle rod (7, fig. 28) at the

(10) Remove the screws (4, fig.

26) and

throttle crank (12) by removing the cotter pin

lockwashers that secure gage (3) to the tank

(11) from the pin (10) and removing the pin from

and remove gage, being careful not to damage

the rod end (4).

the float.

(3) Disconnect the throttle rod at the carburetor and

(11) Remove the drain plug (17, fig. 25) from the

remove rod from the truck.

tank.