Click here to make tpub.com your Home Page

Page Title: TM-10-3930-627-34

• TECHNICAL MANUAL
• SAFETY PRECAUTIONS
• Direct Support and General Support Maintenance Manual
• Cleaning and Inspection.
• Appendix a. REFERENCES
• Distribution
• Table Of Contents
• LIST OF ILLUSTRATIONS
• Chapter 1. INTRODUCTION
• Table 1-2. Engine Limits and Clearances
• Table 1-3. Mast Parts, Wear Limits
• Chapter 2. DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
• Figure 2-2. Thrust bearing retainer construction details.
• Figure 2-4. Piston ring compressor construction details.
• Table 2-2. Troubleshooting Chart
• Table 2-2. Troubleshooting Chart
• Transmission and Torque Converter
• Figure 2-5. Mast removal.
• Transmission and Torque Converter - continued
• Figure 2-6. Transmission, partially exploded view.
• Figure 2-7. Torque converter
• Drive Axle
• Figure 2-9. Drive axle, exploded view.
• Steering Gear
• Figure 2-10. Steering gear removal.
• Steering Axle
• Figure 2-11. Steering axle, exploded view.
• Chapter 3. REPAIR OF ENGINE
• Figure 3-1. Values and camshaft, exploded view.
• Figure 3-2. Removing valve guide.
• Figure 3-4. Crankshaft and related parts, exploded view.
• Figure 3-5. Timing gear cover.
• Flywheel, Ring Gear and Flywheel Housing
• Oil Pan
• Inspection.
• Figure 3-11. Engine block and related parts exploded view.
• Oil Pressure Relief Valve
• Figure 3-13. Rebushing connecting rods.
• Figure 3-15. Measuring piston ring end gap.
• Crankshaft and Bearings
• Figure 3-18. Checking crankshaft end play.
• Camshaft and Bearings
• Cooling System Maintenance
• Chapter 4. REPAIR OF FUEL SYSTEM
• Figure 4-1. Carburetor, exploded view.
• Cleaning.
• Figure 4-2. Governor, exploded view.
• Disassembly.
• Muffler Repair
• Chapter 5. REPAIR OF RADIATOR
• Chapter 6. REPAIR OF ELECTRICAL UNITS
• Figure 6-1. Alternator, exploded view.
• Figure 6-2. Stripping end frame.
• Figure 6-3. Diode Check.
• Starting Motor Test
• Figure 6-5. Starting motor, exploded view.
• Starting Motor Reassembly
• Chapter 7. REPAIR OF TRANSMISSION
• Figure 7-1. Transmission, hydraulic diagram.
• Figure 7-2. Power flow through transmission.
• Preliminary  Troubleshooting  Checks  of Transmission
• Figure 7-4. Transmission pressure check points.
• Transmission Linkage Adjustments
• Figure 7-5. Transmission arrangement.
• Figure 7-6. Oil pump and front case.
• Clutch Assembly
• Figure 7-8. Case and gear train, exploded view.
• Transmission Assembly
• Figure 7-9. Transmission valve, exploded view.
• Chapter 8. REPAIR OF DRIVE AXLE
• Figure 8-1. Drive axle, exploded view.
• Cleaning and Inspection
• Reassembly, Adjustment, and Installation
• Figure 8-2. Transmission-to-differential gasket requirement.
• Figure 8-3. Proper pinion-to-differential ring gear tooth contact pattern.
• Reassembly  of  Power  Train  to  Engine.
• Chapter 9. REPAIR OF STEERING AXLE
• Chapter 10. BRAKE REPAIR
• Figure 10-1. Hand brake arrangement.
• Master Cylinder Repair
• Figure 10-2. Hydraulic brake arrangement.
• Wheel Cylinder Repair
• Figure 10-3. Brake wheel cylinder.
• Chapter 11. STEERING GEAR
• Steering Gear Repair
• Disassembly.
• Removal.
• Installation.
• Installation.
•  Assembly.
• Chapter 12. REPAIR OF HYDRAULIC COMPONENTS
• Figure 12-1. Mast, exploded view.
• Disassembly.
• Figure 12-2. Hoist cylinder, exploded view.
• Hydraulic Pump
• Figure 12-3. Hydraulic pump, exploded view.
• Tilt Cylinder Repair
• Control Valve Repair
• Disassembly.
• Figure 12-6. Control valve, exploded view.
• Assembly.
• Appendix A. REFERENCES
• INDEX
• TM-10-3930-627-34
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• Blank Page
• Distribution