 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 b. Installation.
KEY to figure 2-9):
1. Outer cone and roller bearing
(1) Jack or block up front of truck for convenience
2. Outer bearing cup
and safety during installation of drive axle. Support
3. Final drive gear case
engine so its weight does not depend on the
4. Gasket
transmission for support.
5. Inner bearing cup
(2) With wheeled floor jack under differential
6. Inner cone and roller bearing
housing, roll assembly to mate with transmission of
7. Internal gear
truck.
8. Axle shaft
(3) Install gaskets (16 and 17, fig. 2-6) and secure
9. Ball bearing
axle to transmission. Reverse procedure in a. above.
10. Axle shaft bearing retainer
11. Axle housing
2-9. Steering Gear
12. Stud
a. Removal.
It is not necessary for any repair
13. Gasket
operation to remove both the steering gear and the
14. Gasket
steering column at the same time. These items can be
15. Washer
separated at the flange shown in figure 2-10, permitting
16. Nut
removal only of the item needing service without
17. Tapered bushing
disturbing the other item. Refer to the following steps
18. Washer
only as far as necessary to remove the desired
19. Bearing cap
assembly.
20. Washer
21. Screw
22. Bearing retainer
23. Washer
24. Screw
25. Cotter pin
26. Nut
27. Washer
28. Brake assembly
29. Washer
30. Nut
31. Washer
32. Screw
33. Brakedrum seal
34. Brakedrum
35. Gasket
36. Final drive shaft
37. Screw
38. Screw
39. Screw
40. Washer
2-13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals