 |
|||
|
|
|||
|
Page Title:
Figure 7-3. Nondestructive Inspection Data (Sheet 1 of 2) |
|
||
| ||||||||||
|
|
 TM 10-3930-623-34
Part Name and No.
Type of Test
Test Procedure
Acceptable Defects
Carburetor
1. Visual inspection of parts.
1. Refer to para 7-18.
None.
2. Inspection of unit in
2. Look for fuel leaks.
operation.
Fuel pump
1. Visual inspection of parts.
1. Refer to para 7-20.
None.
2. Before installation test.
2. Refer to para 7-21.
3. After installation test.
3. Refer to para 7-22.
Water pump
1. Visual inspection.
1. Refer to para 7-23.
None.
2. Operational inspec-
2. Inspect for leaks at
tion.
engine governed speed.
Starting motor
1. Visual inspection of
1. Brushes may be worn to
components.
half of original length.
2. Electrical test of
2. Refer to para 7-24,
2. None.
components.
3. Operational tests of
3. Refer to para 7-30
3. None.
assembly.
and 7-32.
Distributor
1. Visual inspection and
None.
test of components.
2. Operational tests.
2. Refer to para 7-35
None.
and 7-36.
Cylinder head
Visual inspection for
Refer to para 7-38.
0.004 inch low lengthwise,
cracks and surface
0.003 inch low crosswise.
warpage.
Cylinder block
1. Visual inspection for
1. Check machined top
1. 0.004 inch low length-
cracks and top surface
surface with straight
wise, 0.003 inch low cross-
irregularities.
edge for warpage.
wise.
2. Micrometer inspection
2. Refer to para 7-38.
2. Taper less than 0.008
of cylinder bores.
inch, out-of-round less than
0.003 inch. Scratches less
than 0.001 deep.
Camshaft
Visual inspection.
Refer to para 7-39.
Refer to para 7-39.
Valves (engine)
Visual inspection.
Refer to para 7-40.
See figure 7-1.
Intake
(Figure 7-3 Sheet 1 of 2)
Figure 7-3. Nondestructive Inspection Data (Sheet 1 of 2)
(Figure 7-3 Sheet 2 of 2)
7-7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals