 |
|||
|
|
|||
|
Page Title:
Figure 7-3. Nondestructive Inspection Data (Sheet 2 of 2) |
|
||
| ||||||||||
|
|
 TM 10-3930-623-34
Part Name and No.
Type of Test
Test Procedure
Acceptable Defects
Tappets
Visual inspection.
Examination.
Two minor pits per
tappet face.
Valve springs
Use shop valve spring
Refer to para 7-40.
Refer to figure 7-1.
tester.
Engine oil pump
Measurement.
Measure gear to housing
Clearance less than 0.003
clearance with feeler
inch.
gage. Refer to para 7-41.
Crankshaft
Visual, with micro-
Refer to para 7-42.
Refer to para 7-42.
meter and dial indica-
tor.
Connecting rods
Visual, with shop rod
Refer to para 7-44.
Refer to para 7-44.
alignment tester.
Transmission
1. Visual inspection of
1. Refer to para 7-46.
None.
parts.
2. Road test.
2. Refer to para 7-86.
Drive axle
Visual inspection of
Refer to para 7-47.
None.
parts.
Brake master cylinder
Visual inspection and
Refer to para 7-48.
None
test for leakage.
Steering axle
Visual inspection.
Refer to para 7-52.
None.
Steering gear
Visual inspection and
Refer to para 7-53 and
None.
road test.
Hoist hydraulic system
Visual inspection for
Operate system fully
None.
leaks.
loaded, then inspect for
leaks.
Hydraulic pump
Visual and functional
Refer to para 7-56 and
None.
inspection.
Hoist and tilt cylinders
Visual and functional
Refer to para 7-58 and
Slight weeping of hydrau-
inspection.
lic fluid at exposed
parts of cylinder
plungers.
Hydraulic control valve
Visual inspection.
Refer to para 7-60.
None.
Figure 7-3. Nondestructive Inspection Data (Sheet 2 of 2)
7-8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals