|
|
TM10-3930-628-12
CHAPTER 4
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Section I. SERVICE UPON RECEIPT OF MATERIAL
(2) Using a hoist of sufficient capacity, lift battery into
4-1.
Inspecting and Servicing the Equipment.
compartment.
a. Refer to paragraph 2-1 and inspect the
(3)
Service and charge battery as described in
truck.
b.
Service the truck as described in paragraph
(4) Connect battery receptacle as shown in figure 2-3.
2-1.
Caution: Do not reverse polarity of battery cables.
4-2.
Installation
of
Separately
Packed
Components
a.
Fire Extinguisher and
Forks.
Refer to
forks.
b.
Battery.
(1) Open battery compartment and remove
side panels.
Section II. MOVEMENT TO A NEW WORKSITE'
4-3.
Dismantling for Movement
4-4.
Reinstallation after Movement
Refer to paragraph 2-3 for removal of forks if required in
If forks were removed to transport the lift truck, refer to
moving the truck or transporting by means of another
carrier.
Section III. REPAIR PARTS, SPECIAL TOOLS ,AND EQUIPMENT
perform organizational maintenance of the fork lift
4-5. Tools and Equipment
truck.
Tools, equipment and repair parts issued with or
4-7. Maintenance Repair Parts
authorized for the fork lift truck are listed in the basic
issue items list, appendix C.
Repair parts and equipment are listed and illustrated in
the repair parts and special tools list ITM 10-3930-628-
4-6. Special Tools and Equipment
20P) for the fork lift truck.
No special tools and equipment are required to
Section IV. LUBRICATION INSTRUCTION
b. Refer to paragraph 4-50 to service the
4-8.
General
reservoir and breather.
These paragraphs contain lubrication instructions which
4-11. Brake Master Cylinder
are supplemental to, and not specifically covered in the
lubrication order.
a. The brake system must be checked and
serviced at regular intervals.
4-9.
Hydraulic Filter
b. Refer to paragraph 4-34 to fill the master
a. Replacement of the filter element is
cylinder.
required at regular intervals.
4-12. Drive Axle
b. Refer to paragraph 4-51 to service the
hydraulic filter.
a. The drive axle requires addition of lubricant
and draining and refilling at regular intervals.
4-10. Hydraulic Reservoir
b. To drain axle differential, remove drain plug
a. The hydraulic system reservoir and breather
must be serviced at regular intervals.
4-1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |