APPENDIX C BASIC ISSUE ITEMS LIST AND MAINTENANCE AND OPERATING SUPPLIES

TM10-3930-628-12

APPENDIX C

BASIC ISSUE ITEMS LIST AND MAINTENANCE

AND OPERATING SUPPLIES

Section I. INTRODUCTION

C-1.

Scope

Code

Explanation

This appendix lists items which accompany the Truck,

Repair parts which are not procured or stocked.

Lift, Fork or are required for installation, operation, or

The requirement of such items will be filled

operator's maintenance.

by use of the next higher assembly or

C-2.

General

component.

This Basic Issue Items List is divided into- the following

Repair parts which are not stocked.

The

sections:

indicated maintenance category requiring

a. Basic Issue Items-Section II. A list of items

such repair parts will attempt to obtain them

which accompany the Truck, Lift, Fork and are required

through cannibalization. Where such repair

by the operator / crew for installation, operation, or

parts

are

not

obtainable

through

maintenance.

cannibalization, requirements will be

b. Maintenance and Operating Supplies-Section III.

requisitioned, with accompanying just-

A listing of maintenance and operating supplies required

ification, through normal supply channels.

for initial operation.

Repair parts authorized for local procurement.

C-3.

Explanation of Columns

Where such repair parts are not obtainable

The following provides an explanation of columns in the

from local procurement, requirements will

tabular list of Basic Issue Items, Section II.

be requisitioned through normal channels

a. Source, Maintenance, and Recoverability Codes

accompanied by a supporting statement of

(SMR).

non-availability from local procurement.

(1) Source code, indicates the selection status

Major assemblies that are procured with

and source for the listed item. Source codes are:

PEMA funds for initial issue only as

exchange assemblies at DSU and GSU

Code

Explanation

level. These assemblies will not be stocked

Repair parts which are stocked in or supplied

above GS and DS level or returned to depot

from the GSA/ DSA, or Army supply system

supply levels.

and authorized for use at indicated

maintenance categories.

(2) Maintenance code, indicates the lowest category

Repair parts which are procured and stocked for

of maintenance authorized to install the listed item. The

insurance purposes because the combat or

maintenance level code is:

military essentially of the end item dictates

Code

Explanation

that a minimum quantity be available in the

Operator/ crew

supply system.

(3)

Recoverability code, indicates whether

Repair parts which are not procured or stocked,

unserviceable items should be returned for recovery or

but are to be manufactured in indicated

salvage. Items not coded are expendable. Recover-

maintenance levels.

ability codes are:

Assemblies which are not procured or stocked

as such, but are made up of two or more

Codes Explanation

units.

Such component units carry

individual stock numbers and descriptions,

Repair parts and

assemblies

which

are

are procured and stocked separately and

economically reparable at DSU and GSU

can be assembled to from the required

activities and are normally furnished by

assembly

indicated

maintenance

supply on an exchange basis.

categories.

Repair parts and assemblies which are

Parts and assemblies which are not procured or

economically reparable at DSU and GSU

stocked and the mortality of which normally

activities and which are normally furnished

is below that of the applicable end item or

by supply on an exemption list s.

When

component. The failure of such part or

items are determined by RCC to be

assembly should result in retirement of the

uneconomically reparable they will be

end item from the supply system.

evacuated to a depot for evaluation and

analysis before final disposition.

C-1