Differential Lockout Shift Control

TM 10-3930-242-34

Figure 5-2. Rear propeller shaft, disassembly and reassem-

bly.

NOTE

(b) If backlash is under minimum specifi-

c a t i o n , back off nut on flange half and tighten

Torque all bolts and screws to torque as specified in

n u t on opposite side. Operation should be done

e. Installation. Refer to paragraph 27 and

i n one notch steps until correct backlash is ob-

tained.

i n s t a l l the axle assembly.

(c) Tighten carrier cap bolts to specified

5-7. Differential Lockout Shift Control

t o r q u e (see torque chart). Recheck backlash. If

a. General. The front differential lockout

b a c k l a s h is not within limits, repeat above pro-

m e c h a n i s m is mounted on the forward portion

c e d u r e to correct. Install bearing adjusting nut

of the axle housing just to the right of the diffe-

locks and secure with screw and lockwasher;

rential assembly (reference point from the

l o c k w i r e to prevent loosening.

o p e r a t o r ' s seat). The rear differential lockout

m e c h a n i s m is mounted on the rear of the axle

(6) Install carrier housing (96) to axle hous-

h o u s i n g just to the left of the differential as-

ing (164).

s e m b l y . Both lockout mechanisms are actuated

(7) Reassemble axle assembly in reverse

hydraulically by depressing the left pedal in the

o r d e r of disassembly.

o p e r a t o r ' s compartment. The differential lock-