Adjust backlash 0.008-0.011 as follows:

TM 10-3930-242-34

Figure 5-1. Front propeller shaft, disassembly and reas-

sembly.

(4) Reassemble differential assembly in

(a) If backlashes too great, back off ad-

c a r r i e r (96 thru 123). Insure that punch marks

justing nut on plain half case and tighten oppo-

on case (123) and gear (122) are properly aligned

s i t e side until all lash is removed. Tighten nut

and that center punch marks on carrier leg (96)

on plain half case solidly to seat bearings. Back

and cap (103) are aligned for proper fit. Tighten

off nuts on flange side, one notch at a time and

t o specified torque.

f o l l o w with opposite nut until correct backlash

(5) Adjust backlash 0.008-0.011 as follows:

is obtained.