|
|
TM10-3930-242-12
battery post connector and that the
negative (-) cable is grounded to the
voltage regulator and bracket.
engine. When installing the receptacle,
place the positive (+) connector up in
relation to its mounted position. Failure
to do so will result in damage to the
the receptacle slave connector.
NOTE: REMOVE NUT (4) AND SCREW (8)
THAT SECURE VOLTAGE REGULATOR
AND BRACKET TO CYLINDER BLOCK,
TA031861
and installation.
NOTE: TAG AND DISCONNECT ELECTRICAL
LEADS AS NECESSARY.
TA031860
starter and solenoid.
b. Cleaning and Inspection.
(1) Clean the starter and solenoid with
drycleaning solvent (item 1, App F) and dry
a. On-Equipment Testing. Refer to paragraph
thoroughly.
4-33a and test voltage regulator and engine
(2) Inspect the starter mounting hardware and
housing for cracks and breaks. Inspect wiring for
b. Removal. Tag electrical leads. Refer to figure
cuts and deterioration. Inspect for corrosion.
4-24 and remove the voltage regulator and bracket.
c. Installation. Refer to figure 4-25 and install
the starter and solenoid.
c. Cleaning and Inspection.
NOTE
(1) Clean the voltage regulator and bracket
When replacing starter with new starter
with drycleaning solvent (item 1, App F) and dry
P/N 1114717, the engine oil dipstick must
thoroughly.
be moved or otherwise altered or clear the
(2) Inspect bracket for cracks or breaks. In-
new starter.
spect voltage regulator for loose hardware,
corrosion, and damaged connectors. Replace all
defective parts.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |