 |
|||
|
|
|||
|
Page Title:
STARTER ASSEMBLY MAINTENANCE (152 HP) |
|
||
| ||||||||||
|
|
 TM 10-3930-660-24-2
STARTER ASSEMBLY MAINTENANCE (152 HP)
THIS WORK PACKAGE COVERS
Disassembly, Cleaning, Inspection, Assembly
INITIAL SETUP
Tools and Special Tools
Materials/Parts - Continued
Tool kit, general mechanic's (Item 39, WP 0324 00)
Lockwasher (31, 38 and 54)
Shop equipment, fuel and electrical (Item 22, WP
Rivet (21)
References
Materials/Parts
Oil, lubricating (Item 32, WP 0323 00)
Paper, emery (Item 36, WP 0323 00)
TM 10-3930-660-10
Bearing (5)
Equipment Condition
Gasket (27 and 32)
Starter removed (WP 0064 00)
Grommet (11)
DISASSEMBLY
NOTE
Clamp starter, drive end down, in a vise.
1.
Remove screw (1) to disconnect connector (2) from
1
2
11
solenoid switch terminal.
7
8
2.
Remove two through bolts (3) and coil end frame (4).
15
3.
If necessary for replacement, remove bearing (5) and
13
22
wick (6). Discard bearing.
21
14
4.
Remove screw (7) and carefully lift field frame (8)
12
17
and associated parts off armature (9) and drive hous-
19
ing (10).
16
5.
Remove connector (2) and grommet (11).
18
24
6.
Remove two pins (12) to free holders (13 and 14) and
20
18
23
springs (15) from supports (16).
19
7.
Remove four screws (17 and 18) and four brushes
14
(19). Two brush ground leads (20) are also attached
5
6
with screws (17).
4
13
3
15
409-1107
8.
Remove brushes (19) from holders (13 and 14).
9.
If necessary, remove four rivets (21) and two supports
(16). Discard rivets.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals