HYDRAULIC TUBING REPLACEMENT - TM-10-3930-660-24-10869

TM 10-3930-660-24-1

HYDRAULIC TUBING REPLACEMENT

0196 00

THIS WORK PACKAGE COVERS

Removal, Installation

INITIAL SETUP

Materials/Parts - Continued

Tools and Special Tools

Tag, marker (Item 57, WP 0323 00)

Tool kit, general mechanic's (Item 39, WP 0324 00)

Lockwasher (5)

Shop equipment, common no. 1 (Item 20, WP 0324

Equipment Condition

Materials/Parts

Vehicle parked on level ground (TM 10-3930-660-

10)

Cap and plug set (Item 8, WP 0323 00)

WARNING

Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting

unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 3,000 psi

(20685 kPa), even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to

the ground and shut down engine. Move control levers through all operating positions, then SLOWLY

loosen hydraulic tank filler cap. After maintenance, tighten all connections before applying pressure.

Escaping hydraulic fluid under pressure can penetrate the skin, causing injury or death.

At operating temperature hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting any

hydraulics. Failure to do so could result in injury.

CAUTION

Wipe area clean around all hydraulic connections to be opened during removal. Cap lines and plug openings

after removing lines. contamination of hydraulic system could result in premature failure.

NOTE

If more than one hydraulic line is to be removed, identify lines to ensure proper installation. Use container to

catch any hydraulic oil that may drain from system.