 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
HYDRAULIC HOSES, LINES AND FITTINGS MAINTENANCE - CONTINUED
0195 00
INSPECTION
1.
Inspect all fittings for damaged threads and for damaged or otherwise damaged O-ring seals, if so equipped.
2.
Inspect hose assemblies for cuts, breaks and for signs of deterioration that could lead to leaks.
INSTALLATION
CAUTION
If removed, torque elbow and adapter to 55 lb-ft (75 Nm) during installation. Do not overtighten. Failure to
follow this instruction could result in damage to transmission hose ports.
NOTE
Remove caps and plugs as hoses are installed. Wipe all sealing surfaces on hoses, and components to which
they connect, clean and dry. Apply a film of clean hydraulic oil to all O-ring seals on fittings as fittings are
installed.
1.
Install fittings and hose assemblies (1 thru 174) as applicable.
2.
If installing a fitting equipped with an O-ring, first apply clean hydraulic oil to O-ring.
3.
If previously drained, refill hydraulic reservoir to proper level (WP 0032 00).
4.
Start engine and operate all hydraulic systems in which hose assemblies and/or fittings have been replaced. Check care-
fully for leaks (TM 10-3930-660-10).
END OF WORK PACKAGE
0195 00-16
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals