|
|
TM 10-3930-660-24-1
MLRS ATTACHMENT CYLINDER REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Personnel Required
Tools and Special Tools
Three
Tool kit, general mechanic's (Item 39, WP 0324 00)
Shop equipment, common no. 2 (Item 19, WP 0324
Equipment Condition
Vehicle parked on level ground (TM 10-3930-660-
10)
Lifting device, 4,000 lb capacity
Parking brake set (TM 10-3930-660-10)
Materials/Parts
Boom extended approximately 3 ft (TM 10-3930-
Cap and plug set (Item 8, WP 0323 00)
660-10)
Compound, anti-seize (Item 11, WP 0323 00)
MLRS attachment cylinder fully retracted (TM 10-
3930-660-10)
Sealant, Loctite (Item 43, WP 0323 00)
MLRS attachment forks level (TM 10-3930-660-
Tag, marker (Item 57, WP 0323 00)
10)
Locknut (9)
MLRS attachment approximately 2 in. (5 cm) off
ground (TM 10-3930-660-10)
Lockwasher (2, 4 and 12)
WARNING
Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting
unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 3,000 psi
(20685 kPa), even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to
the ground and shut down engine. Move control levers through all operating positions, then SLOWLY
loosen hydraulic tank filler cap. After maintenance, tighten all connections before applying pressure.
Escaping hydraulic fluid under pressure can penetrate the skin, causing injury or death.
At operating temperature hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting any
hydraulics. Failure to do so could result in injury.
CAUTION
Wipe the area clean around all hydraulic connections to be opened during removal and disassembly. Cap oil
lines and plug holes after removing lines. Contamination of the hydraulic system could result in premature
failure.
NOTE
If more than one hydraulic line is to be removed, identify lines to ensure proper installation. Use container to
catch any hydraulic oil that may drain from system.
Remove caps and plugs as holes are installed. Wipe all sealing surfaces on valve and hoses clean and dry.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |