|
|
TM 10-3930-660-24-1
MLRS ATTACHMENT CYLINDER REPLACEMENT - CONTINUED
0185 00
REMOVAL
1.
Remove capscrew (1), lockwasher (2), clamp (3) and
lockwasher (4) from each of the two bearing caps (5).
Discard lockwashers.
2.
Disconnect two hydraulic lines (6).
3.
Support rear portion of MLRS attachment cylinder (7)
using a hoist and sling or equivalent supporting
device.
3,4
WARNING
13
1,2
B
A
Failure to support rear portion A of MLRS
10
attachment cylinder when removing pivot
pin may cause severe personal injury and
8
5
damage to cylinder.
9
4.
Remove locknut (9) and bolt (10). Discard locknut.
11,12
5.
Remove pivot pin (8).
7
11,12
13
6
409-705
WARNING
Failure to support cylinder during removal may cause severe personal injury and damage to equipment.
NOTE
If desired, use a hoist with slings of appropriate length in place of personnel to support cylinder in steps 6
thru 15. Slings must be long enough to lower cylinder to ground without interference from boom.
6.
Support MLRS attachment cylinder (7) using two peo-
ple.
7.
Remove six bolts (11) and six lockwashers (12). Discard lockwashers.
8.
Temporarily insert two bolts (11) into two jack bolt holes (13).
9.
Tighten two bolts (11) evenly until bearing cap (5) is loosened.
10.
Remove two bolts (11) from jack bolt holes (13).
11.
Remove bearing cap (5) using a small pry bar.
12.
Repeat steps 7 thru 11 for other bearing cap (5).
13.
Remove MRLS attachment cylinder (7). If necessary, lift MLRS attachment away from forward end of MLRS attach-
ment cylinder (6).
0185 00-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |