STE/ICE-R WIRING HARNESS MAINTENANCE - TM-10-3930-660-24-10555

TM 10-3930-660-24-1

STE/ICE-R WIRING HARNESS MAINTENANCE

0112 00

THIS WORK PACKAGE COVERS

Testing, Repair, Removal, Installation

INITIAL SETUP

Tools and Special Tools

Materials/Parts - Continued

Tag, marker (Item 57, WP 0323 00)

Tool kit, general mechanic's (Item 39, WP 0324 00)

Tape, electrical (Item 58, WP 0323 00)

Shop equipment, common no. 1 (Item 20, WP 0324

Lockwasher (4 and 8)

Materials/Parts

Equipment Condition

Battery cables disconnected (WP 0107 00)

Strap, tie down (Item 56, WP 0323 00)

NOTE

Tag all electrical connections before removing for use during installation.

TESTING

Inspect wires for poor connections, cuts or other defects.

Check continuity of wires.

Connect ohmmeter leads to each end of wire.

A zero reading indicates a broken wire.

REPAIR

NOTE

If three or more of the wires in a wiring harness have been repaired or replaced, replace complete harness.

Replace individual terminal rings and connectors if contact is broken.

Disconnect faulty wire at both ends.

Cut insulation back approximately 4 in. (102 mm).

Cut replacement wire to required length and install proper terminals.

Route replacement wire along wiring harness, securing wire with tie straps or electrical tape.

Connect replacement wire to original connection points.

Test circuit function.