 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
BOOM ELECTRICAL CABLE MAINTENANCE - CONTINUED
0111 00
REPAIR
NOTE
If three or more of the wires in a wiring harness have been repaired or replaced, replace complete harness.
Three spare wires are included in wiring harness to be used if required.
1.
Replace any broken terminal rings or connectors.
2.
Disconnect faulty wire at both ends.
3.
Cut insulation back approximately 4 in. (102 mm).
4.
Cut replacement wire to required length and install proper terminals.
5.
Route replacement wire along wiring harness, securing wire with tie down straps or electrical tape.
6.
Connect replacement wire to original connection points.
7.
Test circuit function.
END OF WORK PACKAGE
0111 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals