 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
STE/ICE-R WIRING HARNESS MAINTENANCE - CONTINUED
0112 00
REMOVAL
NOTE
If an individual wire is broken, it is not necessary to replace entire wiring harness. Refer to Repair.
1.
Note connection points of all terminal rings and single connectors on wiring harness.
2.
Disconnect terminal rings and single connectors.
3.
Disconnect plug-type connector (1) from resistor module. Remove four screws (2), nuts (3) and lockwashers (4) to
detach connector (1). Discard lockwashers.
4.
Remove cap (5).
5.
Remove four screws (6), nuts (7) and lockwashers (8) to detach diagnostic connector (9). Discard lockwashers.
6.
Disconnect plugs from fuel pressure, fuel filter, fuel solenoid and tachometer jacks.
7.
Remove 12 tie down straps, as required, that secure wiring harness. Remove wiring harness. Discard tie down straps.
INSTALLATION
1.
Route new wiring harness in same path as old wiring harness.
2.
Install new tie down straps, as required, in original locations.
3.
Connect fuel pressure, fuel filter, fuel solenoid and tachometer connectors.
4.
Attach diagnostic connector (9) using four screws (6), nuts (7) and new lockwashers (8). Install cap (5).
5.
Attach plug-type connector (1) using four screws (2), nuts (3) and new lockwashers (4).
6.
Connect individual terminal rings and single connectors according to notes taken during removal.
7.
Connect battery cables (WP 0107 00).
8.
Test all circuits to ensure proper connection of wiring harness.
0112 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals