 |
|||
|
|
|||
|
Page Title:
Figure 11-27.Camshaft, disassembly and reassembly. |
|
||
| ||||||||||
|
|
 TM 10-3930-630-34
e. Check camshaft bearing inside diameter.
(4) If bearings do not meet tolerances, replace
bearings (8, 9 and 10, fig. 11-27).
(1) Front bearing inside diameter must be
(5) Use a suitable driving tool and drive
1.8755 to 1.8745 inches (47.63 to 47.61 mm).
bearing from block. Use a suitable bearing installer and
(2) Center bearing inside diameter must be
install new bearing in block. When installing new
1.7802 to 1.7495 inches (44.45 to 44.43 mm).
bearing, be sure to line up oil hole in bearing with oil
(3) Rear bearing inside diameter should be
hole in block.
1.2505 to 1.2495 inches (31.76 to 31.73 mm).
TA067467
1.
Nut
6. Thrust plate
2.
Camshaft gear
7. Camshaft
3.
Key
8. Bearing
4.
Screw
9. Bearing
5.
Lock washer
10. Bearing
Figure 11-27.Camshaft, disassembly and reassembly.
11-20
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals