Figure 4-76. Parking brake lever, installed view.

TM 10-3930-630-12

Figure 4-76. Parking brake lever, installed view.

(6) Loosen clevis locknut and turn clevis three

(4) Remove cotter pin and washer and remove

or four turns clockwise to shorten the cable. Install

cable pin and disconnect cable from lever.

clevis on cam lever and secure with clevis pin and cotter

(5) Disconnect cable from brake cam lever (b

pin.

(5) above), remove clamps and remove cable.

(7) Engage brake and check braking action.

d. Installation.

Adjust cable above until action is correct. Tighten

locknut to secure adjustment.

(1) Install cable (b (5) above) and connect

c. Removal

cable to cam lever. Install clamps to secure cable to

(1) Place brake lever in released position

frame.

(forward).

(2) Install end of cable in parking brake lever

(2) Loosen setscrew securing adjusting knob

(fig. 4-76) and secure cable with cable pin, washer and

and rotate knob counterclockwise to release tension on

cotter pin.

cable.

(3) Install mounting screws (Fig. 4-76),

(3) Remove

two

screws

(Fig.

476),

lockwashers and nuts and secure lever to frame.

lockwashers and nuts and disengage lever from frame.

(4) Refer to b. above and adjust lever and

Remove spacers.

cable.

4-84