Figure 4-17. Tilt cylinder yoke, install view.

TM 10-3930-630-12

(4) Check tilt cylinder (fig. 4-16) for secure

(3) Support tilt cylinder with a block of wood.

mounting at frame and mast. c. Removal.

(4) Remove screw (fig. 4-16) and lockwasher

(1) Remove floor and toe plates.

securing locking pin and remove locking pin and pivot

(2) Disconnect hoses (fig. 4-16) from tilt

cylinder.

(5) Remove cotter pins and remove yoke pin

Plug hose ends and cylinder ports.

4-17) from cylinder and mast.

Figure 4-17. Tilt cylinder yoke, install view.

e. Tilt Adjustment.

(6) Remove cylinder from truck.

NOTE

d. Installation.

(1) Position cylinder in truck with yoke in line

Place truck on a flat level surface

with mast. Install pin (fig. 4-17) through mast and yoke.

to check and adjust mast tilt.

Secure pin with two cotter pins (fig. 4-17).

(2) Install pivot pin (fig. 4-16) through end of

(1) Normal tilt on model ACC40-24PS100

cylinder and frame and secure with locking pin (fig. 4-

trucks is 3 forward and 10 backward. Operate tilt

16), screw and lockwasher.

cylinders and check tilt angle with a protractor (fig. 4-

(3) Install floor and toe plates.

18). Make sure both cylinders have reached the end of

(4) Bleed hydraulic system (para 4-32).

their stroke.

4-26