Section II. MOVEMENT TO A NEW WORKSITE

TM 10-3930-630-12

Section II. MOVEMENT TO A NEW WORKSITE

4-4. Reinstallation after Movement If forks were removed to

4-3. Dismantling for Movement

transport the lift truck, refer to figure 4-1 and install the forks

The only components that may require dismantling for

on the carriage.

movement are the forks. If necessary to conserve space when

transporting the lift truck by means of another carrier, refer to

figure 4-1 and remove the forks.

Section III. REPAIR PARTS, SPECIAL TOOLS

AND EQUIPMENT

4-7. Maintenance Repair Parts

4-5. Tools and Equipment

Repair parts and equipment are listed and illustrated in the

Tools, equipment, and repair parts, with or authorized for the

repair parts and special tools list (TM 10-39304630-20P, to be

fork lift truck, are listed in the basic issue items list and items

published), for the fork lift truck.

troop installed or authorized, appendix C.

46. Special Tools and Equipment

No special tools or equipment are required to perform

organizational maintenance on the fork lift truck.

Section IV. LUBRICATION INSTRUCTIONS

4-8. General

Refer to paragraph 4-90 and service the master

cylinder.

4-11. Drive Axle

These paragraphs contain lubrication instructions

which are supplemental to and not specifically covered in the

The drive axle requires addition of lubricant and

lubrication order.

draining and filling at regular intervals.

The axle breather requires service at regular

intervals.

4-9. Hydraulic Filter and Reservoir

To drain axle differential, remove drain plug at

bottom of housing. Fill axle differential through level plug

Replacement of the filter is required at specified

located on cover side of the housing.

intervals.

A hydraulic filter element indicator (fig. 3-5) is

Refer to paragraph 4-95 to service axle and

located at the right side of the instrument panel The indicating

breather.

line (fig. 3-5) should be in line with the green band. This

indicates filter element is operating properly. If indicating line is

4-12. Transmission

in line with the yellow band, element is becoming

contaminated and should be changed at earliest convenience.

The transmission requires service at regular

When white indicating line reaches any portion of the red

intervals. A daily check of the oil level is required.

band, change element immediately.

To drain transmission, place a suitable

container under the drain plug, remove drain plug and drain

Refer to paragraph 4-43 and service the

transmission.

hydraulic filter.

c. A filter screen is mounted in the transmission

The hydraulic reservoir and breathers must be

serviced at regular intervals.

sump.

The screen should be serviced every time the

transmission oil is change

Refer to paragraph 4-44 and service the

d. Refer to paragraph 4-101 to service transmission

reservoir and breather.

and screen.

To drain reservoir, place a suitable container

under reservoir. Remove drain plug and drain reservoir.

Install drain plug and fill reservoir through level

4-13. Engine Oil Filter

gage hole.

a. The engine oil filter must be changed at regular

intervals; the filter is replaceable and requires no servicing.

4-10. Brake Master Cylinder

b. Refer to paragraph 4-80 and replace the engine oil

filter when necessary.

The brake system must be checked and

serviced at regular intervals.

4-4