|
|
(3) Unplug and connect hydraulic lines.
2-10. Reservoir
(4) Connect wires to thermal relays.
a. Removal.
(5) Fill reservoir (TM 10-3930-620-12).
(1) Disconnect
battery
and
discharge
2-11. Steering Wheel, Column, and Gear
capacitors (para 2-5).
a. Removal.
(2) Drain all oil from the reservoir.
(1) Disconnect
battery
and
discharge
(3) Tag and disconnect the hydraulic lines to
capacitors (para 2-5).
the power steering pump, hydraulic pump, and the
(2) Remove floor plate and toe plate (TM 10-
hydraulic oil filter.
3930-620-12).
(4) Tag and disconnect wires to thermal
(3) Tag and disconnect hydraulic lines from
the steering gear unit. (fig. 2-7)
(5) Plug all lines to prevent dirt from entering
(4) Plug all hydraulic lines to prevent dirt from
the system.
entering the system.
(6) Remove the hydraulic oil filter.
(5) Disconnect horn leads.
(7) Remove the bolts that secure the reservoir
(6) Remove the two nuts, lock washer, and
to the truck, and lift out the reservoir.
b. Installation.
screws securing steering gear unit to bracket.
(7) Remove steering wheel, column, and gear
(1) Mount the reservoir to the truck and
from lift truck.
secure with bolts.
(2) Install the hydraulic oil filter.
Figure 2-7. Steering wheel, column
b. Installation.
(2) Install wheel chocks forward and aft of
front wheels to prevent lift truck from moving.
(1) Mount steering wheel, column, and gear
(3) Using a suitable lifting device, raise front
using the two screws, lock washers, and nuts. (fig. 2-7.)
end of lift truck above the ground, as required.
(2) Connect horn leads.
(4) Install blocking and remove lifting device.
(3) Unplug and connect hydraulic lines.
(5) Tag and disconnect hydraulic inlet and
2-12. Power Steering Pump
outlet lines from power steering pump. (fig. 2-8.)
a. Removal.
(6) Plug ends of both hydraulic lines to
(1) Disconnect
battery
and
discharge
prevent dirt and other foreign matter from entering
capacitors (para 2-5).
hydraulic system.
2-9
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |