 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-611-35
b.
Cleaning, Inspection and Repair.
(2) Inspect for breaks, cracks, wear, loose
or missing mounting hardware, or other damage.
(1) Clean all parts with dry cleaning
(3) Tighten or replace loose or missing
solvent (Federal Specification P-D-680) and dry
mounting hardware, replace a damaged or defective
thoroughly.
part as necessary.
(2) Inspect for breaks, cracks, damaged
c. Installation
parts, chipped paint, loose or missing mounting
hardware, or other defects.
(1) Refer to figure 3-30 and install the
(3) Tighten or replace loose or missing
brake drum and mounting plate.
mounting hardware, replace a damaged or defective
(2) Install the brake shoes (para 3-24).
part as necessary.
3-26. Differential
c. Installation.
a. Removal.
(1) Refer to figure 3-33 and install the
front panel.
(1) Remove the mast assembly (para 3-
(2) Install the accelerator linkage (TM 10-
3930-611-12).
(2) Refer to figure 3-21 and remove the
(3) Install the directional switch (TM 10-
differential.
b. Disassembly. Refer to figure 3-32 and
3930-611-12).
disassemble the differential assembly.
(4) Connect the accelerator switch (TM
c. Cleaning, Inspection and Repair.
10-3930-611-12).
(5) Install the steering column (para 3-16).
(1) Clean all parts with dry cleaning
(16) Install the stack valve switches and
solvent (Federal Specification P-D-680) and dry
controls (TM 10-3930-611-12).
thoroughly.
(7) Install the two front floor plates (TM
(2) Inspect for breaks, cracks, chipped
10-3930-611-12).
gears, damaged threaded areas, loose or missing
(8) Install the horn (TM 10-3930-611-12).
mounting hardware, or other defects.
(3) Tighten or replace loose or missing
mounting hardware, replace a damaged or defective
part as necessary.
reassemble the differential assembly.
e. Installation.
(1) Refer to figure 3-31 and install the
differential.
(2) Install the mast assembly (para 3-10).
3-27. Operator Console Components
a. Removal.
(1) Remove the horn (TM 10-3930-611-
12).
(2) Remove the two front floor plates (TM
10-3930-611-12).
(3) Remove the stack valve switches and
controls (TM 10-3930-611-12).
(4) Remove the steering column (para 3-
(5) Disconnect the accelerator switch (TM
10-3930-611-12).
(6) Remove the directional switch (TM
10-3930-611-12).
(7) Remove the accelerator linkage (TM
10-3930-611-12).
(8) Refer to figure 3-33 and remove the
front panel.
Figure 3-33. Front panel, removal and installation.
3-39
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals