F o r w a r d a n d r e v e r s e c o m p o n e n t s

TM 10-3930-242-34

Figure 4-2. Torque converter and transmission assembly,

didaddembly and reassembly (sheet 3 of 13).

(f) R e m o v e t h e f o r w a r d a n d r e v e r s e a n .

(3) F o r w a r d a n d r e v e r s e c o m p o n e n t s ( f i g .

chor pin (125).

(g) R e m o v e t h e f o r w a r d a n d r e v e r s e

(a) If not previously removed, remove the

c l u t c h anchor assembly (99).

a l u m i n u m spacer which positions the reverse

NOTE

r a n g e planetary carrier assembly.

The forward carrier, ring gear, and two remaining

(b) Remove 12 forward-reverse clutch pis-

forward clutch plates cannot be removed until the

ton return springs (97, fig. 4-2), and pins (96).

r a n g e gears and clutches are removed from the

rear of the transmission housing.

(c) Remove five external tanged reverse

(h) Remove two external tanged and two

range clutch plates (88) and four internal

s p l i n e d reverse range clutch plates (89).

i n t e r n a l splined forward clutch plates (88).

(d) Remove the reverse range planetary

(4) Removal of transmission housing.

(a) Position the transmission upright, at-

carrier (1) and remaining intern al splined clutch

plate (89).

t a c h a sling to the transmission housing (120,

(e) Remove the forward and reverse sun

gear (98) and the thrust washer (92) beneath it.

(b) W h i l e s u p p o r t i n g t h e h o u s i n g w i t h a