Figure 3-141. Cylinder Liner Remover

TM 10-3930-634-34

CAUTION

Do not force the piston into the liner. Use ex-

tra care during this loading operation to pre-

vent ring breakage.

(h) Remove theconnecting rod bearing cap and

ring compressor and push the piston down into the

liner until the compression rings pass the liner ports.

(z) After the piston and connecting rod assembly

have been installed in the liner, install the entire as-

sembly as follows:

1. Make sure the seal ring groove in the

cylinder block is clean. Then install a new seal ring.

2 . Apply a hydrogenated vegetable type

shortening or a permanent type antifreeze solution to

the inner surface of the seal ring.

3. If any of the pistons and liners are already

in the engine, use hold-down clamps (fig. 3-144) to re-

tain the liners in place when the crankshaft is rotated.