ARCTIC HEATER KIT INSTALLATION - continued

TM 10-3930-673-34

17-3. ARCTIC HEATER KIT INSTALLATION (CONT)

(46) At left-side of vehicle frame near starter,

remove nut (61) from ground stud (62). Leave

existing cable or wires in place.

(47) Connect ring terminal of wire no. 2 (63) of

heater wiring harness (54) to ground stud (62)

and install new external tooth lockwasher (64)

over ground stud. Install nut (61).

(48) Secure heater wiring harness to transmission

cooler hoses, existing vehicle wiring harness,

and fender support bracket with small tie

wraps.

(49) Connect negative battery cable (TM 10-3930-

673-20-2).

(50) Remove existing fan drive belt (TM 10-3930-

673-20-2) and install new arctic (extended temperature) fan drive belt.

NOTE

Stencils are not supplied with arctic heater kit.

(51) At rear of heater assembly, apply stencil in 1

in. high black letters "WARNING OPEN

COOLANT VALVE AT ENGINE BEFORE

OPERATION".

(52) At side of heater assembly, apply stencil in 1

in. high black letters the word "ON" above

the word "OFF".

END OF TASK

17-12

Change 1