 |
|||
|
|
|||
|
Page Title:
ARCTIC HEATER KIT INSTALLATION - continued |
|
||
| ||||||||||
|
|
 TM 10-3930-673-34
(40) Start engine (TM 10-3930-673-10) and check
for coolant leaks. Tighten connections as
necessary. Stop engine.
(41) Disconnect negative battery cable (TM 10-
3930-673-20-2).
(42) Connect large circular connector (53) of
heater wiring harness (54) to heater assembly
(14).
(43) Route heater wiring harness (54) as shown
and connect rectangular connector (55) of
heater wiring harness (54) to fuel pump (26).
(44) Route heater wiring harness (54) inside
vehicle frame and across flywheel housing of
engine.
(45) Remove nut (56) from screw (57) of "L"
shaped copper terminal (58) of starter. Place
ring terminal of wire no. 9 (59) of heater
wiring harness (54) and new external tooth
lockwasher (60) over screw. Install nut.
Change 1
17-11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals