REAR DIFFERENTIAL CARRIER ASSEMBLY REPLACEMENT/REPAIR/ ADJUSTMENT - continued

TM 10-3930-673-34

9-5. REAR DIFFERENTIAL CARRIER ASSEMBLY REPLACEMENT/REPAIR/

ADJUSTMENT (CONT)

WARNING

Use care when installing snap and

retaining rings. Snap and retaining

rings are under spring tension and

can act as projectiles when released

and could cause severe eye injury.

(d)

Install snap ring (43) into groove on

end of bevel pinion (29).

(e)

Apply thin film of gear lubricant to

inner and outer bearing cups (41

and 42) and bearing cones (38 and 39).

(f)

Install bearing spacer (40) on bevel pinion against inner bearing cone (39).

(g)

Install bevel pinion (29) and bearing assembly into bearing cage (30).

(h)

Use press and suitable sleeve driver to install outer bearing cone (38) on bevel pinion tight

against bearing spacer (40).

(i)

Install pinion bearing cage thrust washer (37).

(2)

Adjust preload of bearings (38, 39, 41,

and 42) on bevel pinion (29).

(a)

Install companion yoke (9),

washer (32), and nut (31) on bevel

pinion (29). If necessary, use a press

to push yoke on pinion. Companion

yoke must be against thrust

washer (37).

NOTE

Shims are not installed at this time.

(b)

Temporarily install bevel pinion (29)

and bearing cage (30) assembly in

differential carrier (2). Do not install

shims (34) under bearing cage.

(c)

Install eight screws (33) in bearing

cage (30) finger tight.

9-16