REAR DIFFERENTIAL CARRIER ASSEMBLY REPLACEMENT/REPAIR/ ADJUSTMENT - continued

TM 10-3930-673-34

(f)

Remove outer bearing cone (38) from bearing cage (30).

(g)

Use suitable puller to remove inner bearing cone (39) and bearing spacer (40) from bevel

pinion (29).

(h)

Use suitable puller to remove inner bearing cup (41) and outer bearing cup (42) from bearing

cage (30).

(i)

Install a soft metal cover over vise jaws to protect bevel pinion (29). Place bevel pinion (29) in

vise.

WARNING

Use care when removing snap and retaining rings. Snap and retaining rings are under

spring tension and can act as projectiles when released and could cause severe eye

injury.

(j)

Remove snap ring (43) from end of bevel pinion (29).

(k)

Use suitable puller to remove bearing (44) from spigot end of bevel pinion (29).

c. Cleaning. See Cleaning Instructions (Para 2-12).

d. Inspection. See Inspection Instructions (Para 2-14).

e. Assembly.

NOTE

Pinion and ring gears are a matched set. If replacement of ring gear or pinion gear is

necessary, replace both gears as a set.

(1)

Assemble bevel pinion (29),

bearings (38, 39, 41, and 42), and

bearing cage (30).

(a)

Use press and suitable driver to

install inner bearing cup (41) and

outer bearing cup (42) into bearing

cage (30). Be sure bearing cups are

tight against bottom of cage bore.

(b)

Use press and suitable sleeve driver

to install inner bearing cone (41) on

bevel pinion (29).

TR00436

(c)

If necessary, use a press and

suitable sleeve driver to install

spigot bearing (44) onto spigot end of bevel pinion (29).

9-15