TRANSMISSION OUTPUT SHAFT REPLACEMENT/REPAIR/ADJUSTMENT

TM 10-3930-673-34

7-6. TRANSMISSION OUTPUT SHAFT REPLACEMENT/REPAIR/ADJUSTMENT

This Task Covers:

a. Removal

c. Inspection

e. Adjustment

b. Cleaning

d. Installation

INITIAL SETUP

Equipment Condition (Cont)

Tools and Special Tools

Transmission oil drained (TM 10-3930-673-20)

Tool Kit, General Mechanic's: Automotive

Transmission removed (Para 7-4)

(Item 23, Appendix D)

Shop Equipment, Automotive Maintenance and

Materials/Parts

Repair; Field Maintenance, Basic, Less Power (Item

Oil, Hydraulic (Item 30, Appendix B)

18, Appendix D)

Packing, Preformed

Dial Indicator (Item 3, Appendix D)

Packing, Preformed

Gear Puller (Item 15, Appendix D)

Ring, Retaining

Seal

Equipment Condition

Seal

Front and rear propeller shafts removed

Wood Blocks

(TM 10-3930-673-20)

a. Removal.

(1)

Remove screw (1), washer (2), shims

(3), preformed packing (4), and yoke (5)

from output shaft (6). Discard

preformed packing.

(2)

Place transmission (7) horizontally on

wood blocks with splines of output shaft

(6) facing upward.

(3)

Mark position of output cap (8) on

transmission (7) for ease in installation.

(4)

Remove two screws (9) from output cap

(8).

(5)

Remove two nuts (10) from two studs

(11) of transmission (7).

CAUTION

TR00237

Use care when removing output cap.

Failure to follow this precaution will

damage oil baffle pan inside transmission.

NOTE

Spur gear and bearing cone will slide free

of output shaft and will be removed as

output cap is removed.

7-50

Change 1