 |
|||
|
|
|||
|
Page Title:
FORK SIDESHIFT CYLINDERS REPLACEMENT |
|
||
| ||||||||||
|
|
 TM 10-3930-673-20-2
16
This Task Covers:
a. Removal
b. Installation
INITIAL SETUP
Materials/Parts
Tools and Special Tools
Compound, Sealing (Item 29, Appendix C)
Tool Kit, General Mechanic's: Automotive
Compound, Sealing (Item 33, Appendix C)
(Item 18, Appendix F)
Rags (Item 26, Appendix C)
Shop Equipment, Automotive Maintenance, Common
Tags (Item 39, Appendix C)
No. 2 Less Power
Lockwashers (2)
(Item 15, Appendix F)
Preformed Packings (2)
Cap and Plug Set (Item 3, Appendix F)
Container, 1 gal (3.79 l) capacity
Equipment Condition
Parking brake set
Personnel Required
Wheels chocked
Two
Boom in horizontal position, properly supported (TM
10-3930-673-10)
References
Forks removed (Para 18-16)
TM 10-3930-673-10
a. Removal.
WARNING
Hydraulic oil in system can be under pressures over 3000 psi (20685 kPa) with engine OFF.
ALWAYS relieve pressure in hydraulic hoses before attempting to remove any component in
hydraulic system. With engine OFF, starter switch in RUN position, and attachment on ground,
move control levers through all operating positions several times to relieve hydraulic pressure.
Relieve pressure in hydraulic oil tank by loosening filler cap very slowly. Failure to follow these
precautions could result in serious injury or death to personnel.
At operating temperatures, hydraulic oil is hot and under pressure. Hot oil can cause injury to
personnel. Allow hydraulic oil to cool before disconnecting any hydraulic hoses.
CAUTION
Wipe area clean around all hydraulic connections to be opened during removal and disassembly. Cap
oil hoses and plug holes. Contamination of hydraulic system could result in equipment failure.
NOTE
Use suitable container to catch any hydraulic oil that may drain from system.
Remove caps and plugs as hoses are installed. Wipe all sealing surfaces on hydraulic components
and hoses clean and dry. Apply light coating of clean hydraulic oil to all seals as installed.
Left and right fork sideshift cylinders are removed and installed the same way. Right fork sideshift
cylinder shown.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals