 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-673-20-2
8-20. FORK AUTOLEVELER SWITCH REPLACEMENT/ADJUSTMENT (CONT)
NOTE
Any slack in autoleveler cable must be
located at boom electrical box end of
cable.
(2)
Connect fork autoleveler cable (2) in
connector (3) of boom electrical box (4) and
TR00004
tighten collar (1).
(3)
Connect negative battery cable (Para 8-44).
(4)
Adjust autoleveler switch. Refer to
4
adjustment of fork autoleveler switch section
below.
2
1
3
TR00351
c. Adjustment.
(1)
Start engine (TM 10-3930-673-10). Position
attachment (6) in down position so that tilt
cylinder is fully extended.
11
(2)
Adjust autoleveler switch (5).
5
(a)
Turn on fork autoleveler control in cab (TM
10-3930-673-10).
6
(b)
Raise forks approximately 24 in. (609.6 mm)
above ground.
(c)
Place level on forks and note level reading.
NOTE
Level reading should be within +2 degrees of zero if switch is properly adjusted.
(3)
Adjust autoleveler switch (5).
(a)
Turn three locknuts (11) on switch (5) to adjust as required until 0 degree reading is shown on level.
(b)
Turn off fork autoleveler control in cab and manually tilt attachment up or down.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals