|
|
TM 10-3930-673-20-1
Section II.
SERVICE UPON RECEIPT
a. Remove any plastic tape, wrapping paper or any other shipping and protective items.
WARNING
Drycleaning solvent P-D-680 (Type II) is a flammable solvent that is potentially dangerous to
personnel. Keep away from heat, sparks, or open flame. Flash point of solvent is l38 F (58 C). Use
only in a well-ventilated area. Inhaling vapors over a period of time can cause headache and
drowsiness. Use gloves to prevent irritation or inflammation of the skin. Solvent absorbed through the
skin can result in internal disorders. If contact occurs, wash the affected area with water for 15
minutes. For eyes, flush with water and then seek immediate medical attention.
b. Clean any exposed metal parts coated with rust preventive compound. Remove compound with cleaning solvent.
c. Read and follow all instructions contained in DD Form 1397 attached to the ATLAS.
d. Inspect equipment for damage incurred during shipping. If equipment has been damaged, report the damage on DD
Form 6, Packing Improvement Report.
e. Check equipment against the packing slip to see if the shipment is complete. Report all discrepancies in accordance with
DA Pam 738-750.
f. Clean all exterior surfaces.
g. Touch up any paint scratches.
a. Perform the operator preventive maintenance checks and services (PMCS) contained in TM 10-3930-673-l0.
b. Perform the organizational preventive maintenance checks and services (PMCS) contained in Table 2-1.
c. Lubricate all points as shown in the TM 10-3930-673-l0 PMCS and the TM 10-3930-673-20 PMCS regardless of
interval.
d. Schedule the next preventive maintenance checks and services (PMCS) on DD Form 314, Preventive Maintenance
Schedule and Record.
e. Report all deficiencies on DA Form 2407 if the deficiencies appear to involve unsatisfactory design.
f. Check that all decals and plates are on vehicle.
g. Make sure vehicle is ready for operation; remove all warning tags.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |