 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
CARRIAGE TILT CYLINDER REPAIR - CONTINUED
0307 00
DISASSEMBLY - CONTINUED
1.
Use a suitable tool to pull rod (2) out approximately 5
in. (12.7 cm) for removal of gland (3).
4
2.
Place a container under gland (3) to catch oil con-
tained in cylinder.
3.
Use a spanner wrench to unscrew gland (3) from cyl-
inder tube (4). Pull gland (3) out of cylinder far
6
enough to unseat O-ring (5). Allow oil to drain into
1
container.
6
7
9
8
5
3
2
10
409-1391
CAUTION
Use care when removing rod and piston assembly to prevent wear ring damage. Keep rod in line with cylin-
der tube to prevent binding.
4.
Remove rod (2) and piston assembly from cylinder tube (4).
5.
Place rod (2) and piston assembly on suitable supports to prevent damage.
6.
Remove two wear rings (6).
CAUTION
Do not nick or scratch seal groove during removal of seal. Failure to follow this precaution will cause part
damage.
7.
Cut seal (7) and discard.
NOTE
The nut may need to be heated with a torch for removal.
8.
Remove nut (8) and washer (9).
0307 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals