 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
REAR DIFFERENTIAL CARRIER ASSEMBLY MAINTENANCE - CONTINUED
0298 00
DISASSEMBLY - CONTINUED
9.
Inspect ring gear (8) for wear or damage. If ring gear (8) needs replacement, center punch twelve rivets (19) on side of
ring gear (8).
10.
Drill twelve rivets (19) on ring gear (8) to a depth equal to thickness of one rivet head. Use a drill bit 1/32 of an inch
(0.793 mm) smaller than rivet body diameter.
11.
Press or drive twelve rivets (19) from drilled side
7
through holes in ring gear (8) and flange case half
(20). Discard rivets.
A
12.
Support assembly under ring gear (8) with blocks and
use a press to remove case half (20) through ring gear
(8).
13.
Place differential carrier (7) on bench and clamp car-
409-1285
rier securely.
14.
Fasten yoke nut tool to companion yoke. Hold yoke
nut tool (A) to remove bevel pinion nut (21) and
washer (22).
7
15.
Remove companion yoke (23) with deflector (24). Use
28
a puller if necessary.
16.
Remove eight capscrews (25).
17.
Remove bevel pinion (26), bearing cage (27), and
25
shims (28), as an assembly, from the differential car-
rier (7). Keep shims together for use during assembly.
26
23 22
If shims are damaged, measure total thickness of shim
pack and record dimension. Discard shims. Shim
27
21
thickness dimension will be needed to calculate depth
29 24
of bevel pinion in differential carrier when gear set is
409-1286
installed.
18.
Use a suitable puller to remove pinion oil seal (29)
from bearing cage (27). Discard seal.
0298 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals