 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
REAR DIFFERENTIAL CARRIER ASSEMBLY MAINTENANCE - CONTINUED
0298 00
DISASSEMBLY - CONTINUED
4.
Remove two bearing caps (1), two bearing adjusting
rings (3) and two bearing cups (6).
4
5
A
3
1
2
409-1283
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
5.
Use a sling to lift differential carrier (7) and ring gear
6
9
(8) as an assembly and place assembly on a work
bench.
6.
Remove flange case half bearing cone (9) and plain
14
case half bearing cone (10) with a suitable puller.
15
20
14
13
NOTE
8
12
19
11
17
If matching marks on the case halves of
16
the differential are not visible, mark each
18
case half with a center punch and hammer.
10
The match marks are to ensure proper case
6
halves orientation at assembly.
409-1284
7.
Remove eight capscrews (11) and eight flatwashers
(12) from plain case half (13) and separate the case
halves.
8.
Remove two side gear thrust washers (14), two side
gears (15), four pinion gears (16), four pinion gear
thrust washers (17) and differential spider (18).
0298 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals