 |
|||
|
|
|||
|
Page Title:
REAR DIFFERENTIAL CARRIER ASSEMBLY MAINTENANCE |
|
||
| ||||||||||
|
|
 TM 10-3930-660-24-2
REAR DIFFERENTIAL CARRIER ASSEMBLY MAINTENANCE
THIS WORK PACKAGE COVERS
Disassembly, Cleaning, Inspection, Assembly, Adjustment
INITIAL SETUP
Materials/Parts - Continued
Tools and Special Tools
Tool kit, general mechanic's (Item 39, WP 0324 00)
Rivets (19)
Shop equipment, automotive maintenance (Item 21,
Seal (29)
Shim pack (28)
Differential resistance tool (Item 7, WP 0324 00)
Wood block
Driver, group (Item 9, WP 0324 00)
Yoke nut tool (Item 47, WP 0324 00)
References
Lifting device, 4,000 lb capacity
Materials/Parts
Compound, marking (Item 13, WP 0323 00)
TM 10-3930-660-10
Compound, sealing (Item 14, WP 0323 00)
Equipment Condition
Sealant, Loctite (Item 46, WP 0323 00)
Rear axle assembly removed (WP 0245 00)
Oil, lubricating (Item 32, WP 0323 00)
Axle housing lubricant drained (WP 0125 00)
Rag, wiping (Item 40, WP 0323 00)
Rear planetary wheel ends removed (WP 0248 00)
Cotter pin (2)
DISASSEMBLY
1.
Use center punch and hammer to mark one carrier leg
(A) and bearing cap (1) to enable correct matching at
reassembly.
2.
Remove cotter pins (2) holding two bearing adjusting
4
5
A
rings (3) in position. Discard cotter pins.
3.
Remove two capscrews (4) and two flatwashers (5)
from each of two bearing caps (1).
3
1
2
409-1283
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals