 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
TURBOCHARGER ASSEMBLY REPAIR (165 HP) - CONTINUED
0282 00
ASSEMBLY - CONTINUED
30.
Measure radial clearance of turbocharger shaft and
wheel (19).
31.
Attach a dial indicator to turbine housing (1). Adjust
dial indicator plunger so that plunger is against end of
19
impeller (18) between fins and nut (20).
20
32.
Set dial indicator to zero.
1
33.
Move end of impeller (18) left and right and read
radial clearance on dial indicator. If radial clearance is
less than 0.0128 in. (0.3251 mm) or greater than 0.018
18
in. (0.4572 mm), disassemble turbocharger, Steps 8-
25, and check for problem. Replace defective parts
and assemble, steps 2-29.
409-1831
34.
Position compressor housing (13) on bearing housing (14).
14
13
15
6
WARNING
12
Use care when installing snap and retaining
rings. Snap and retaining rings are under spring
10
tension and can act as projectiles when released
and could cause severe eye injury.
35.
Install retaining ring (15) on compressor housing (13)
and bearing housing (14).
36.
Install bracket (6), spacer (12), three spacers (11),
washers (10) and screws (8 and 9) on turbine housing
(1).
11
9
1
10
8
11
4TR-1820
0901385
0282 00-11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals