 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
STEERING KNUCKLE MAINTENANCE - CONTINUED
0250 00
INSTALLATION - CONTINUED
3.
Install steering knuckle (12) end of axle.
4.
Apply grease to groove face of thrust washer (8).
5.
Install shims (9 thru 11) and thrust washer (8) on
lower steering knuckle cap (7). Tabs (B) on thrust
washer must be up.
6.
Install lower cap assembly. Ensure that thrust washer
(8) tabs engage slots in end of axle housing before
final tightening of capscrews (1).
7.
Apply loctite to threads of capscrews (1). Torque cap-
screws (1) to 85 to 117 lb-ft (115 to 159 Nm).
8.
Install shims (3 thru 5) on upper steering knuckle cap
(2).
12
9.
Install upper cap assembly.
11
10.
Apply loctite to threads of capscrews (1). Torque cap-
10
screws (1) to 85 to 115 lb-ft (115 to 159 Nm).
11.
Repeat steps 1 thru 10 for other steering knuckle, if
9
necessary.
B
8
7
409-1340
12.
Install planetary wheel ends (WP 0244 00 and WP 0248 00).
13.
Install tie rod (WP 0251 00).
14.
Adjust tie rod (WP 0138 00).
ADJUSTMENT
1.
If wheels are on ground, use a feeler gauge to measure gap between upper steering knuckle cap shoulder and top
machined surface of end of the axle housing.
2.
If wheels are removed (axle supported by blocks), use a hydraulic jack or pry bar to push steering knuckle up until bot-
tom of steering knuckle is tight against bottom of axle. Measure gap as in step 1.
3.
Vertical end play may also be measured by checking maximum vertical movement of knuckle with a dial indicator.
4.
Record measurement.
5.
If end play is 0.013 in. (0.33 mm) or less, no adjustment is necessary.
6.
If vertical end play exceeds 0.013 in. (0.33 mm), go to step 9.
0250 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals