|
|
TM 10-3930-660-24-2
TRANSMISSION ASSEMBLY REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Cleaning, Inspection, Installation
INITIAL SETUP
Materials/Parts - Continued
Tools and Special Tools
O-ring (45 and 49)
Tool kit, general mechanic's (Item 39, WP 0324 00)
Wood block
Shop equipment, automotive maintenance (Item 21,
References
Lifting device, 10,000 lb capacity
WP 0173 00
Materials/Parts
Cap and plug set (Item 8, WP 0323 00)
TM 10-3930-660-10
Oil, lubricating (Item 33, WP 0323 00)
Sealant, Loctite (Item 43, WP 0323 00)
Personnel Required
Two
Strap, tie down (Item 56, WP 0323 00)
Tag, marker (Item 57, WP 0323 00)
Equipment Condition
Cotter pin (11)
Transmission oil drained (WP 0118 00)
Lockwashers (2, 5, 10, 34 and 47)
Transmission cover removed (WP 0150 00)
REMOVAL
WARNING
Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting
unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 3,000 psi
(20685 kPa), even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to
the ground and shut down engine. Move control levers through all operating positions, then SLOWLY
loosen hydraulic tank filler cap. After maintenance, tighten all connections before applying pressure.
Escaping hydraulic fluid under pressure can penetrate the skin, causing injury or death.
At operating temperature hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting any
hydraulics. Failure to do so could result in injury.
CAUTION
Wipe the area clean around all hydraulic connections to be opened during removal and disassembly. Cap oil
lines and plug hoes after removing lines. Contamination of the hydraulic system could result in premature
failure. Use metal caps when specified.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |