 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
TORQUE CONVERTER REPLACEMENT - CONTINUED
0236 00
INSTALLATION
1.
If removed, install grease fitting (16) to torque converter cover (8).
NOTE
Apply a sufficient amount of grease to bearing prior to installation.
2.
If removed, install new seal (13), bearing (15) and snap ring (14) to torque converter cover (8).
3.
If removed, position torque converter input shaft (4) to torque converter assembly (12) and secure with twelve cap-
screws (10), and new lockwashers (11).
CAUTION
Use extreme care not to damage input shaft during installation of torque converter assembly.
NOTE
Fill torque converter with one quart of clean lubricating oil and occasionally tip the converter to the side to
allow oil to flow to bottom of the torque converter.
Clean any spilled oil from inside of bell housing assembly prior to and after installation of torque converter
assembly.
Check torque converter assembly for free movement and is properly seated in bell housing.
4.
Install torque converter assembly (12) into transmission bell housing (9).
5.
Position torque converter cover (8) on torque converter assembly (12) and secure with twelve hex nuts (5), new star-
washers (6) and capscrews (7).
6.
Install yoke (3), washer (2) and nut (1). Torque nut to 300-350 lb-ft (407-475 Nm).
7.
Install transmission driveshaft (WP 0119 00).
8.
Operate equipment and check for proper operation (TM 10-3930-660-10).
END OF WORK PACKAGE
0236 00-3/(-4 Blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals