 |
|||
|
|
|||
|
Page Title:
INSTALLATION OF HANDLE PUSHBUTTON SWITCH |
|
||
| ||||||||||
|
|
 TM 10-3930-660-24-2
ELECTRIC JOYSTICK MAINTENANCE - CONTINUED
0235 00
INSTALLATION OF HANDLE PUSHBUTTON SWITCH - CONTINUED
7.
Solder red electrical lead of joystick to pin 4 of pushbutton switch (16).
NOTE
5
4
6
Align handle section on shaft coupling so
that coupling set screw is facing center of
handle section.
8.
Place one handle section (7) on shaft coupling (14).
5
NOTE
3
Place switch flange in lowest slot with flat
surface of flange facing center of handle
section.
6
2
9.
Install pushbutton switch (16), flange (18) and nut
(17) as a unit to handle section (7).
10.
Install actuating button (15) with smaller diameter of
6
button extending through top of handle section (7).
11.
Place other handle section (7) on shaft coupling (14).
5
12.
Install two screws (11), two new bowed washers (12)
and two nuts (13) at bottom of handle sections (7).
6
1
13.
Install two screws (9) and two nuts (10) at top of han-
dle sections (7).
409-1126
14.
Place boot (8) on handle sections (7).
INSTALLATION OF MICROSWITCHES
NOTE
Plug with red and black leads from upper circuit board connects to microswitch.
Plug with white, blue and yellow leads from upper circuit board connects to microswitch.
Plug with red and black leads from lower circuit board connects to microswitch.
Plug with white, blue and yellow leads from upper circuit board connects to microswitch.
1.
Secure microswitch (1) and two spacers (6) with two screws (5).
2.
Connect plug to microswitch (1).
3.
Repeat steps 1 and 2 for microswitches (2 thru 4).
0235 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals