BOOM ELECTRICAL CABLE REPLACEMENT

TM 10-3930-660-24-2

BOOM ELECTRICAL CABLE REPLACEMENT

0233 00

THIS WORK PACKAGE COVERS

Removal, Installation

INITIAL SETUP

References

Tools and Special Tools

WP 0107 00

Tool kit, general mechanic's (Item 39, WP 0324 00)

WP 0111 00

Materials/Parts

Personnel Required

Strap, tie down (Item 56, WP 0323 00)

Two

Tag, marker (Item 57, WP 0323 00)

Equipment Condition

Tape, electrical (Item 58, WP 0323 00)

Machine parked on level ground (TM 10-3930-660-

10)

Lockwasher (16, 23, 27 and 31)

Load backrest removed from MLRS attachment, if

Rope, 25 ft

stored (TM 10-3930-660-10)

REMOVAL

NOTE

If an individual wire in a wiring harness is broken, it is not necessary to discard entire wiring harness.

Refer to Repair in WP 0111 00.

Tag all electrical connections before removing for use during installation.

Start engine (TM 10-3930-660-10). Raise forks approximately one foot off ground. Stop engine (TM 10-3930-660-10).

Disconnect battery cables (WP 0107 00).

Loosen four screws (1) and separate cover (2) from

boom electrical box (3).

Disconnect four electrical leads (5) at terminal strip

(7) of circuit board (4).

7,8

Loosen four screws (8) on terminal strip (7) and

remove leads (5).

409-421