 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
CARRIAGE TILT CYLINDER REPLACEMENT - CONTINUED
0184 00
REMOVAL - CONTINUED
14.
Remove locknut (9) and retaining bolt (8) from car-
riage tilt cylinder base pin (10). Discard locknut.
10
8
9
15.
Carefully drive pin (10), from inside MLRS attach-
ment, through cylinder base mounting point and
through access hose on side of MLRS attachment.
16.
Remove cylinder (12).
409-701
INSTALLATION
WARNING
Lifting equipment used for lifting cylinder must be in good condition and suitable load capacity. Failure to
follow this warning may cause injury or damage to equipment.
1.
Position carriage tilt cylinder (12) in MLRS carriage using hoist and sling.
2.
Install cylinder base retaining pin (10).
3.
Install retaining bolt (8).
4.
Install new locknut (9).
NOTE
11
11
Remove caps and plugs as hoses are
installed. Wipe all sealing surfaces on
valve and hoses clean and dry.
5.
Connect three hydraulic lines (11) to hydraulic cylin-
der (12) as tagged.
6.
Extend cylinder to align pin hole.
409-4077
12
12
7.
Start vehicle and extend tilt cylinder to align cylinder rod eye and pin access hole (TM 10-3930-660-10).
0184 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals