 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
CARRIAGE TILT CYLINDER REPLACEMENT - CONTINUED
0184 00
REMOVAL - CONTINUED
8.
Remove bolt (13) and locknut (14) which secure cyl-
8
inder rod pivot pin (2). Discard locknut.
9.
Remove rod pivot pin (2).
10.
Retract carriage tilt cylinder.
2
11.
Move MLRS joystick to carriage UP position to
retract cylinder (TM 10-3930-660-10).
13,14
409-4075
NOTE
Return joystick to neutral position as soon as disconnected cylinder is fully retracted. This will prevent the
carriage from being tilted by the other attached cylinder.
12.
Disconnect three hydraulic hoses (11) from carriage
11
11
tilt cylinder (12) to be removed.
WARNING
Lifting equipment used for lifting cylinder
must be in good condition and suitable
load capacity. Failure to follow this warn-
ing may cause injury or damage to equip-
ment.
13.
Support base end of carriage tilt cylinder with a hoist
and sling.
409-4077
12
12
0184 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals