FRAME TILT CYLINDER REPLACEMENT - TM-10-3930-660-24-10795

TM 10-3930-660-24-1

FRAME TILT CYLINDER REPLACEMENT

0183 00

THIS WORK PACKAGE COVERS

Removal, Installation

INITIAL SETUP

Tools and Special Tools

Materials/Parts - Continued

Lockwasher (10)

Tool kit, general mechanic's (Item 39, WP 0324 00)

Wood block

Shop equipment, common no. 1 (Item 20, WP 0324

Personnel Required

Two

Materials/Parts

Equipment Condition

Cap and plug set (Item 8, WP 0323 00)

Vehicle parked on level ground (TM 10-3930-660-

Compound, anti-seize (Item 11, WP 0323 00)

10)

Tag, marker (Item 57, WP 0323 00)

Parking brake set (TM 10-3930-660-10)

WARNING

Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting

unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 3,000 psi

(20685 kPa), even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to

the ground and shut down engine. Move control levers through all operating positions, then SLOWLY

loosen hydraulic tank filler cap. After maintenance, tighten all connections before applying pressure.

Escaping hydraulic fluid under pressure can penetrate the skin, causing injury or death.

At operating temperature hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting any

hydraulics. Failure to do so could result in injury.

CAUTION

Wipe area clean around all hydraulic connections to be opened during removal and disassembly. Cap oil

lines and plug holes after removing lines. Contamination of the hydraulic system could result in premature

failure.

NOTE

If more than one hydraulic line is to be removed, identify lines to ensure proper installation. Use container to

catch any hydraulic oil that may drain from system.