WHEEL ASSEMBLY REPLACEMENT

TM 10-3930-660-24-1

WHEEL ASSEMBLY REPLACEMENT

0134 00

THIS WORK PACKAGE COVERS

Removal, Installation

INITIAL SETUP

Tools and Special Tools

References

WP 0135 00

Tool kit, general mechanic's (Item 39, WP 0324 00)

Shop equipment, common no. 1 (Item 20, WP 0324

Personnel Required

00)

Two

Jack stand, 7,000 lb capacity

Equipment Condition

Materials/Parts

Vehicle parked on level ground (TM 10-3930-660-

10)

Wood blocks

WARNING

Equipment used for lifting vehicle must be in good condition and of correct capacity. Failure to follow

this warning may result in injury or death and damage to equipment.

Improper use of lifting equipment and improper attachment to vehicle can result in injury to personnel

and equipment damage. Observe all standard rules of safety.

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during

procedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep

clear of heavy parts supported only by lifting device. Failure to follow this warning may result in death

or injury.

Always place blocking material between rear axle housing and frame rear axle housing stops before

raising vehicle with floor jack. If blocking material is not used, vehicle will tip to left or right when

front axle housing is raised, possibly resulting in injury to personnel or damage to vehicle.

In addition, if blocking material is not used, rear axle housing will oscillate on its pivot pin when rear

wheel assembly is removed, possibly resulting in injury to personnel or damage to vehicle.