Click here to make tpub.com your Home Page

Page Title: BRAKE SYSTEM HOSES, LINES AND FITTINGS MAINTENANCE
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 10-3930-660-24-1
BRAKE SYSTEM HOSES, LINES AND FITTINGS MAINTENANCE
THIS WORK PACKAGE COVERS
Removal, Repair, Installation
INITIAL SETUP
Tools and Special Tools
References
Tool kit, general mechanic's (Item 39, WP 0324 00)
Shop equipment, common no. 1 (Item 20, WP 0324
TM 9-4940-468-13
Equipment Condition
Materials/Parts
Cap and plug set (Item 8, WP 0323 00)
Vehicle parked on level ground (TM 10-3930-660-
10)
Oil, lubricating (Item 32, WP 0323 00)
Wheels chocked
Tag, marker (Item 57, WP 0323 00)
REMOVAL
WARNING
Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting
unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 3,000 psi
(20685 kPa), even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to
the ground and shut down engine. Move control levers through all operating positions, then SLOWLY
loosen hydraulic tank filler cap. After maintenance, tighten all connections before applying pressure.
Escaping hydraulic fluid under pressure can penetrate the skin, causing injury or death.
At operating temperature hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting any
hydraulics. Failure to do so could result in injury.
CAUTION
Wipe the area clean around all hydraulic connections to be opened during removal and disassembly. Cap oil
lines and plug holes after removing lines. Contamination of the hydraulic system could result in premature
failure.
NOTE
If more than one hydraulic line is to be removed, identify lines to ensure proper installation. Use suit-
able container to catch any hydraulic oil that may drain from system.
Removal and installation procedures for front and rear brake system hoses, lines and fittings are similar.
Tag all electrical connections before removing for use during installation.

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business